Entries close on the 2nd May.
Clarification of Nipper Boards to be used:
Clubs are able to use which boards they prefer at the Championships 1.6 or 2m. As boards will not be pooled clubs are required to bring sufficient to cover their heats.
The decision to introduces the larger 2m Nipper Board was brought in due to the increasing use of these boards within our clubs.
- Consistency between pool and beach, most of the club (if not all) do not use the 1.6m boards for beach events and they prefer the 2m boards.
- New clubs are having to buy 1.6m boards to use at the Pool Championships and store all year where the 2m boards can now be used for both.
- This is only for national events as the lanes are larger in the 50m pool and the boards just do a 50m straight race. Most Regional event will still use the 1.6m boards.
- Some of the larger Nipper are too big for the 1.6m boards and find they sink under the weight and when doing board rescue this can be difficult.
Reminder of the Nipper Board Spec:
1.6m Nipper Board Specification
- Length: 165 cms
- Width: 52 cms
- Material: Polyethylene covered soft foam construction
2m Nipper Board Specification
- Maximum length – 2.0m
- Minimum nose radii – nose and tail in plan view (see below) ~ 25mm
- Minimum radii –leading edge nose and trailing edge tail in elevation view (see below) ~ 3mm
- Minimum structural weight – not specified.
- Minimum width – not specified.
- Only one fin is permitted. Fin must have minimum profile radius of 25mm at any point, and minimum leading edge radius of 3mm and minimum trailing edge radius of 1.5mm. The fin is to be of flexible rubber/plastic material or moulded foam.
NOTE: Leading edge extends from underside of the board to the lowest point of the fin.Nipper Pool Entry Information 2022 Quick Guide to the SLSGB Online Entry System Clarification of Nipper Boards to be use